DallasWater Damage Cleanup (469) 856-7756Get a call back
  1. Home
  2. Guides
  3. Texas Freeze Prep: Burst Pipes and What the February 2021 Storm Taught DFW
Guide

Texas Freeze Prep: Burst Pipes and What the February 2021 Storm Taught DFW

Burst pipe water damage is the Texas winter claim, and February 2021 was its worst week. DFW sat at or below freezing for 139 consecutive hours, from 5 p.m. on February 13 to noon on the 19th, and bottomed out at -2°F on the 16th. The power failed across the metro. By March 31, Texas insurers had logged 456,531 claims from the storm, 81.5 percent of them residential, with an average residential loss of about $11,500 and an expected ultimate insured cost of $8.2 billion. Most of that was water: pipes that froze while the heat was off and split, then sprayed when the thaw came.

Five years on, the lesson hasn't changed and neither have most of the houses. This guide covers what failed in 2021 and why, which DFW homes carry the risk (and where in the house), what to do before the next freeze, and what to do in the hour after a pipe bursts. It's written for the owner of a slab-on-grade house in Plano, Frisco, Arlington or Mansfield with the water heater in the attic, because that's the house that flooded.

What February 2021 did

The National Weather Service's record for DFW: 5 inches of snow, a high on February 15 that was lower than the record low for the date, -2°F on the 16th, and 139 straight hours at or below freezing, tied for eighth-longest on record. Waco went 205 hours. The grid failed under the load and much of North Texas lost power for a day or more in the middle of it, so houses that would have stayed above freezing with the furnace running didn't.

The claims followed. TDI's September 2021 report counted 324,523 claims on residential replacement-cost policies and 47,603 on actual-cash-value policies as of March 31, with $1.57 billion and $163 million paid by then and far more reserved. Commercial property added 34,011 claims. Reviewers of the damage afterward pointed at the same design choices again and again: water heaters and plumbing in ventilated attics, supply lines in exterior walls, and no accessible shutoff.

Why DFW houses burst: the attic

Since the 1980s, DFW builders have put the supply manifold, the water heater and the air handler in the attic. It keeps them out of living space on a slab house with no basement, and it works until the attic is the coldest room in the house. An attic is ventilated to the outside by design; in a 139-hour freeze with the furnace off, the air up there tracks the outdoor temperature, and the few inches of insulation that may or may not cover a supply run are all that stands between the pipe and -2°F. Water heaters in the attic sit in a pan with a drain; a tank that froze and split, or a fitting that let go above it, sends water through the ceiling below.

The Dallas Builders Association's note after the storm: PEX, common in newer homes, is much more resilient to cold than copper, and newer homes had fewer frozen and broken pipes. That matched the field. But PEX fittings are brass or rigid plastic and don't flex, and tankless water heaters mounted on exterior walls froze at the manifold. Older houses had their own version: copper in exterior walls, hose bibs, and garage water heaters against an uninsulated outside wall.

Which DFW housing has attic plumbing

As a rule of thumb by era, with exceptions on every street: houses from the 1950s through the 1970s in Richardson, Garland, south Irving, north Grand Prairie, east Plano and central Arlington have copper supply lines under the slab and in the walls, with the water heater in a garage or hall closet; their freeze failures are exterior-wall pipes and hose bibs, and their year-round failure is the slab leak. Houses from the 1980s are the transition and may have either. Houses from the 1990s onward in west Plano, Frisco, Allen, McKinney, Flower Mound, Lewisville, Rockwall, Mansfield and south Grand Prairie have the manifold, the supply runs, the water heater and the air handler in the attic, in PEX or copper depending on the year and the builder.

If you don't know which you have, open the attic hatch. If you see a water heater, a manifold with a dozen red and blue lines, or supply pipes running across the joists, that's your risk. A plumber can tell you in ten minutes and quote insulating the runs in the same visit.

Before the freeze: insulation, shutoffs, and the outage plan

Insulate every exposed supply run in the attic and the manifold, and make sure the attic insulation covers the pipes rather than lying beside them. Insulate hose bibs and the pipe to any tankless unit on an exterior wall. Find both shutoff valves (the meter at the curb, which may need a meter key, and the house valve, often in the garage or utility room in newer homes) and test that they turn; a valve that hasn't moved in 15 years won't move when you need it. Know where the attic water heater's pan drain terminates outside, because water from that line is your first warning.

When a hard freeze is forecast, especially with the power at risk: drip the faucets farthest from the meter, hot and cold, open cabinet doors under sinks on exterior walls, set the thermostat and leave it, and if the power goes out for more than a few hours in sub-20 weather, consider shutting the house valve and opening the lowest faucet to drain the lines, which is what builders recommended after 2021. The January 2026 freeze was a reminder: Dallas Water Utilities took more than 350 cold-weather calls from January 23 to 27, 207 of them burst pipes, and plumbers reported water heaters failing at a higher rate in the cold.

  • Insulate attic supply runs, the manifold, hose bibs and exterior tankless units
  • Find and test both shutoff valves before December
  • Drip the farthest faucets and open sink cabinets on exterior walls during a freeze
  • In a long outage below 20°F, shut the house valve and drain the lines
  • Put a leak alarm in the attic water heater pan
  • Keep a meter key where you can find it in the dark

When a pipe bursts: the first hour

Shut the water at the house valve or the meter. If the pipe is frozen but hasn't burst yet, leave a faucet open on that line so water has somewhere to go as it thaws, and warm the pipe from the faucet end back toward the frozen section with a hair dryer or hot towels; never an open flame. If water is coming through a ceiling, turn off the breakers for that area and the attic air handler before you go in, put a bucket under the lowest point of any bulge and poke a small drain hole in it so the ceiling comes down in a stream rather than a sheet.

Then photograph everything before you move it, call a restoration crew, call your insurer, and call a plumber, in that order, because drying can't wait for the plumber. In a regional freeze, every crew in DFW is booked; the companies Dallas Water Damage Cleanup sends you triage by severity and will tell you honestly how long. Start with towels and a shop vac on hard floors while you wait, and move what you can to a dry room. Keep the failed section of pipe or fitting when the plumber replaces it: a freeze burst is a sudden and accidental loss on Texas policies, and the part proves it. One exclusion to know: TDI's primer lists freezing pipes while the house is unoccupied as a common exclusion, so a vacant house with the heat off can be denied.

What the cleanup looks like and what it costs

A freeze burst is Category 1 water, so it's the lowest rate: Fixr's January 2025 guide puts extraction and drying at $3.75 to $4.25 per square foot, a DFW company's April 2025 page at $3 to $4, with emergency fees of $50 to $200. What makes freeze jobs expensive is where the water went: from the attic, through the ceiling, down the inside of the walls, across the floor below. The drying area is two floors plus the attic, wet blown-in insulation comes out, and the ceiling is replaced at $325 to $1,100. A one-room ceiling leak caught the same day is often $500 to $1,500 to dry; a burst that ran for hours through a two-story is $2,000 to $5,000 before rebuild.

The crew meters both floors and the attic, removes what's saturated, sets air movers and dehumidifiers, and logs readings daily until the structure is dry, usually five to seven days on a two-floor loss. If the house was without heat and the water sat, expect the category to be upgraded and the scope to grow. The daily log and the photos are the claim.

Questions

Questions people ask

At what temperature do pipes burst in Texas houses?

The risk starts in the 20s and gets serious with sustained time below 20°F, especially when the power is out and the attic tracks the outdoor temperature. In February 2021 DFW spent 139 hours at or below freezing with a low of -2°F. The duration matters more than the low; a short dip to 25 rarely bursts an insulated pipe, and a day at 15 with no heat will.

Does homeowners insurance cover burst pipes from a freeze in Texas?

Usually yes; TDI lists a burst pipe as the textbook sudden and accidental loss, and freezing pipes is a named peril on the HO-A Plus and broader forms. The pipe repair itself is often not covered, but the water damage is. The exception TDI's primer flags: freezing pipes while the house is unoccupied and unheated is a common exclusion.

Why did my pipes burst after the freeze ended, not during?

Because ice split the pipe or a fitting while it was frozen, but nothing flowed until the ice melted and the pressure came back. That's why the floods in 2021 came on the warm-up days. If a pipe froze, shut the house valve before the thaw and open a faucet so you find the break under no pressure instead of full pressure.

Is PEX really safer than copper in a freeze?

Safer, not safe. PEX flexes with expanding ice and survived freezes in 2021 that split copper, which is why newer DFW homes had fewer bursts. The fittings and manifolds don't flex, and PEX fails too if the ice is severe enough. Insulate the attic runs and drip the faucets regardless of pipe type.

Should I drip my faucets or shut off the water during a freeze?

Drip while you have power and heat; shut off and drain if the power goes out for more than a few hours in sub-20 weather, which is what builders recommended after 2021. Dripping keeps water moving so it's harder to freeze; draining means there's nothing in the attic pipes to freeze at all. Either way, know where the house valve is before the storm.

How do I thaw a frozen pipe without bursting it?

Open the faucet it feeds, then warm the pipe from the faucet end back toward the frozen section with a hair dryer, a heating pad or towels soaked in hot water. Never use a torch or open flame. If the frozen section is in the attic or inside a wall where you can't reach it, call a plumber; the Dallas Builders Association warned after 2021 that licensed plumbers were booked for weeks, so call early.

Need a restoration company today? Call (469) 856-7756.

Dallas-Fort Worth only. A local restoration company from our network calls you back. No fee to homeowners.

Call now
Call (469) 856-7756